Heat Exchanger Re-Tube Gone Bad, Then Good Again. As we have been discussing, there are times when it is not possible to effectively repair a piece of equipment. This particular…
Last month, we talked about how some equipment just can’t be revived. Recently, Ward was asked to help a good customer with a leaking half pipe on a pressure vessel…
Recently, a customer sent in two heat exchangers for what they hoped was a partial re-tube. The process had seen small amounts of shell-side water, so they knew there was…
#7 – Poor Design “Poor Design” could mean a lot of things in the world of heat exchangers. It’s critical to understand all the things that factor into the design…
#3 – Corrosion… If your responsibilities include heat exchangers, you probably know that corrosion is a common failure mechanism. Most everyone in the refining and petrochemical worlds sees corrosion on…
#1 – Tube Plugging… If you work around shell & tube heat exchangers, it is likely that you’ve seen or heard of plugged tubes. Plugging can be intentional, where a…